Peugeot 308 Key Fob: The Good, The Bad, And The Ugly
Peugeot 308 Key Fob Replacement
Peugeot's 308 might be catching on a bit however, it's still eye-catching. It's not the most luxurious vehicle in its class, but it's an enjoyable and relaxing driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is persistent or intermittent these tips will aid.
Water Damage
If you leave your key fob in a puddle or get it wet while swimming, kayaking, canoeing, rafting or canyoning, it's more likely to sustain water damage. The best way to avoid this from happening is to keep it in a dry bag whenever you're going outdoors or doing activities where the fob could be exposed to large amounts of water.
It's also crucial to ensure sure the fob has completely dried out before you open the fob and then use it. If you notice any smells emanating from the fob (such as industrial fluid or windshield washer fluid) It's another sign that it has been submerged.
A circuit board that is wet could cause the battery to discharge its charge, or even explode. If you are able to get the 308 keyfob from the water, turn the button side up and shake as much water as you can before opening the casing. Remove dealership , then clean the circuit board using a cotton swab that has been dipped in 90-percent alcohol.
Other reasons your Peugeot 308 remote keyless entry system that you use to enter your home may be unable to function could be due to an empty coin battery problems with the receiver module signal interference, an electronic chip malfunctioning. If none of the above are the reason you can reset the system by disconnecting a 12 voltage battery from the vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start system which allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to stepping inside. This feature is extremely beneficial, especially during cold winter months. But sometimes, the remote start system ceases functioning due to a variety of causes, such as the battery in the coin is dead.
The coin-shaped battery inside the key fob can last between two and four years based on how frequently it is used, the location it was purchased and how it is utilized. The date for use-by will be printed on the packaging or mentioned in the user manual.
If the key fob is not functioning after exposure to clean tap water, you should remove the battery, clean the chip using a paper towel and isopropyl alcohol, then dry it completely before replacing it. If you expose it to soapy or salty water, the chip could be damaged and you'll need to replace the key fob entirely.
If you are not sure the battery is in good condition, you can test its voltage with a multimeter set to your vehicle's voltage range and connected to the plus and minus terminals. If the voltage is lower than 12-13 volts then it is time to replace the battery. Alternatively, you can attempt to reset the onboard computer by disconnecting the battery at 12 volts for a short period of time, and then reconnecting it in reverse order (positive cable first, then negative). The engine should now begin.
Faulty Receiver Module
If you're unable to see the "Key Detected" message on your dashboard, then it's possible that your receiver module has been afflicted with a fault. It's that part that sends an alert to the car when the key fob is activated which acts as an immobiliser, and stops it from starting until the correct key is present.
This could be due to a variety of causes, such as water damage or simply ageing. If your Peugeot 308 key fob was exposed to dirty tap water, as in the electronic chip located inside the device will be damaged. In this instance, you'll need to take the device apart and thoroughly clean it with isopropyl alcohol, or electronic cleaner. When the battery is dry, you can try again.
If the issue persists, it is a good idea to visit an area Peugeot expert or locksmith. They'll be able utilize a diagnostic tool to identify the problem and repair it for you.
It can be stressful to lose your Peugeot car key. However, a trained auto locksmith can solve the issue in just a few minutes. They can program your vehicle and cut a new functioning key for you. Click here to find a locksmith near you.
Electronic chip malfunctions
The electronic chip inside the Peugeot 308 key fob plays an essential function in the remote control system. If it is damaged, your car may not start, or you could get a message saying "anti-theft active". If this happens, the only way to fix the issue is to obtain a new key. Luckily, professional auto locksmiths can offer the service within the shortest period of time.
The chip inside your Peugeot 308 key fob can be damaged by sweat, water damage dirt, or any other cause. If your Peugeot key fob has been exposed to dirty or soapy water, it needs to be cleaned immediately. You can clean the electronic component using a paper towel soaked in isopropyl Alcohol. After that, allow the battery to completely dry.
Radio interference can cause the key fob's functionality to cease. This can happen when other devices operate on the same frequency as your Peugeot keyfob. It could be caused by unsafe conditions or objects that are within the vicinity of the vehicle. It is recommended that you visit a Peugeot dealer if you experience this issue.
The Peugeot 207/308 Key Fob is very delicate and requires special attention. It should not be dropped or throw it around. If you lose it, try to locate it as soon as you can. You can reset your on-board computer by disconnecting the battery for a few minutes. Be sure to disconnect the negative cable first before connecting the positive.